Utilization of fly ash from power plant for adsorption of hydrocarbon contamination in water

Authors

  • Jakkapong Sasithorn Faculty of Engineering, Chulalongkorn University
  • Dawan Wiwattanadate Faculty of Engineering, Chulalongkorn University
  • Supin Sangsuk Metallurgy and Materials Science Research Institute, Chulalongkorn University

Keywords:

Polycyclic aromatic hydrocarbons, Cethyltrimethylammoniumbromide, Naphthalene, Adsorption, Silica from Rice husk

Abstract

Adsorption efficiency of polycyclic aromatic hydrocarbons (PAHs) contamination in water with rice husk fly ash from a power plant was investigated in comparison with coal fly ash and silica from rice husk fly ash, with and without surface treatment. Naphthalene was used as a representative for PAHs,and Cethyltrimethylammoniumbromide (CTAB) was used as surface treating agent for the present study. Various factors, such as shaking rate, shaking time, pH of naphthalene aqueous solution, and adsorbent-naphthalene weight ratio, were investigated to identify the optimum condition for each adsorbent. Upon using 0.3 g adsorbent in 100 ml of 10 mg/l naphthalene solution, the optimum condition was observed to be shaking the mixture of an adsorbent and naphthalene solution with pH 2 at 250 rpm for 60 minutes. Similar optimum conditions were also observed for all adsorbents used in the present study, except for the highest efficiency of silica from rice husk fly ash treated with CTAB. In addition, upon varying weight ratios of adsorbent and naphthalene, adsorption efficiency was observed to gradually increase and reach equilibrium at the ratio of 0.7 g adsorbent per mg naphthalene. Therefore, the optimum condition for the present study should be using 0.7 g adsorbent per mg naphthalene in solution with pH 2 and shaking at 250 rpm for 60 minutes. The adsorption behavior of the system was also investigated and found to be in line with Freundlich Isotherm.

Downloads

Download data is not yet available.

References

Anbia, M. and Moradi, S.E. 2009. Removal of naphthalene from petrochemical wastewater streams using carbon nanoporous adsorbent. Appl. Surf. Sci. 255(9) : 5041-5047.

Bada, S.O. 2007. Adsorption of Phenols onto Fly Ash. Master Thesis. Faculty of Engineering and the Built Environment University of the Witwatersrand, South Africa.

Banerjee, S.S., Joshi, M.V. and Jayaram, V. 2006. Treatment of oil spills using organofly ash. Desalination. 195(1-3) : 32-39.

Banerjee, S.S., Joshi, M.V. and Jayaram, V. 2006. Effect of quaternary ammonium cations on dye sorption to fly ash from aqueous media. J. Colloid Interface Sci. 303(2) : 477-483.

Crisafully, R., Silveira, E.R., Keukeleire, D.D., Milhome, A.L., Cavalcante, R.M. and Nascimento, R.F. 2008. Removal of some polycyclic aromatic hydrocarbons from petrochemical wastewater using low-cost adsorbents of natural origin. Bioresour. Technol. 99(10) : 4515-4519.

Lee, S.Y. and Kim, S.J. 2002. Adsorption of naphthalene by HDTMA modified kaolinite and halloysite. Appl. Clay Sci. 22(1-2) : 55-63.

Parida, S.K., Dash, S., Patel, S. and Mishra, B.K. 2006. Adsorption of organic molecules on silica surface. Adv. Colloid Interface Sci. 121(1-3) : 77-110.

Downloads

Published

2017-04-15

How to Cite

[1]
J. Sasithorn, D. . Wiwattanadate, and S. Sangsuk, “Utilization of fly ash from power plant for adsorption of hydrocarbon contamination in water”, J Met Mater Miner, vol. 20, no. 1, Apr. 2017.

Issue

Section

Original Research Articles