Determination of forming limit stress diagram for formability prediction of SPCE 270 steel sheet

Authors

  • Sansot Panich Faculty of Engineering, King Mongkut’s University of Technology Thonburi
  • Vitoon Uthaisangsuk Faculty of Engineering, King Mongkut’s University of Technology Thonburi
  • Jittichai Juntaratin Iron and Steel Institute of Thailand
  • Surasak Suranuntchai Faculty of Engineering, King Mongkut’s University of Technology Thonburi

Keywords:

Forming limit diagram, Forming limit stress diagram, Failure criterion, Formability, FEM, SPCE 270 steel sheet

Abstract

The aim of this research is to apply numerical Finite Element Method (FEM) for determining Forming Limit Stress Diagram (FLSD) of sheet steel of grade SPCE 270. As a failure criterion for formability prediction in sheet metal forming process, the conventional Forming Limit Diagram (FLD) is often used. The FLD is a strain based criterion, by which the principal strains at failure are evaluated. Many investigations showed that the FLD is dependent on forming history and strain path. However, the stress based criterion does not confirm this dependency. This criterion is more robust against any changes in the strain path occurring in a forming process. To determine the stress based criterion or the Forming Limit Stress Curve (FLSC), the FLD was initially determined by the Limiting Dome Height (LDH) test. Afterwards, the LDH test was simulated by FEM using the FLD data as a failure criterion. Calculated major and minor stresses were used to construct the FLSC. Finally, an industrial automotive part was taken in order to validate the applicability of the FLD and FLSD criterion. The investigations confirmed that the FLD is insufficient for evaluating parts being manufactured in complex forming process with strain path changes. Nevertheless, the results exhibited that the FLSD is a more precise tool for characterizing formability of steel sheet.

Downloads

Download data is not yet available.

References

Stought, T. B. (2001). Stress-base forming limited in sheet metal forming. J. Eng. Mater. Technol. 123(4): 417-422.

Stoughton, T. & Zhu, X. (2004) Review of theoretical models of the strain-based FLD and their relevance to the stress-based FLD. Int. J. Plasticity 20(8-9): 1463-1486.

Uthaisangsuk, V., Prahl, U. & Bleck, W. (2007). Stress base failure criterion for formability characterization of metastable steels. Comp. Mater, Sci. 39(1): 43-48.

Uthaisangsuk, V., Prahl, U., Münstermann, S. & Bleck, W. (2008). Experimental and numerical failure criterion for formability prediction in sheet metal forming. Comp. Mater. Sci. 43(1): 43-50.

Uthaisangsuk, V. (2009). Microstructure based formability modeling of multiphase steels. Ph.D Thesis. RWTH Aachen University: 175.

Veerman, C. (1971). Sheet Metal Industries 48: 678-690.

Downloads

Published

2011-06-30

How to Cite

[1]
S. Panich, V. Uthaisangsuk, J. Juntaratin, and S. . Suranuntchai, “Determination of forming limit stress diagram for formability prediction of SPCE 270 steel sheet”, J Met Mater Miner, vol. 21, no. 1, Jun. 2011.

Issue

Section

Original Research Articles

Most read articles by the same author(s)