Diffusion bonding of stainless ASTM A240 grade 304 in double side flux cored arc welding

Authors

  • Sombat Pitaknorachon King Mongkut’s University of Technology Thonburi
  • Bovornchok Poopat King Mongkut’s University of Technology Thonburi

Keywords:

Double side flux cored arc welding (DS-FCAW), Diffusion

Abstract

Double side flux cored arc welding (DS-FCAW) has been developed from conventional flux cored arc welding (FCAW). DS-FCAW, dual torches are used by placing an opposite to each other and welding on both sides simultaneously. The objective of this research paper is to investigate diffusion bonding effect due to DS-FCAW. Stainless steel ASTM A240 Grade 304 was studied. Other welding parameters were set constant except welding current and voltage. Diffusion bonding was observed even though weld profiles from macro inspection showed lack of penetration by we ld metal in all experiments. It can be concluded that, at certain conditions, the welds can pass both mechanical test and microstructure examination because diffusion bonding process was completely developed due to high contraction stress and high temperature. The advantage of DS-FCAW is that the required joint mechanical properties can be achieved in single welding which results in reduction of welding time and cost.

Downloads

Download data is not yet available.

References

Dunkerton, S.B. 1993. The Welding Institute, Procedure Development and Practice Considerations for diffusion welding. In : ASM Hand Book. Volume 6 : Welding Brazing and Soldering. New York : ASM International : 884.

Mahoney, Murray W. and Bampton, Cliff C. 1993. Rockwell International Science Center. Fundamental of Diffusion Bonding. In : ASM Hand Book Volume 6 : Welding Brazing and Soldering. New York : ASM International : 156-159.

Gould, Jerry, E. Mechanisms of Bonding for Solid-State Welding Process. Edison Welding Institute. : 1-3, 6-7.

O’Brien, R.L. 1991. Welding Handbook, 8th ed. New York : American Welding Society : 814-818.

Dave, V.R., Beyerlein, I.J., Hartman, D.A. and Barbieri., J.M. A Probabilistic Diffusion Weld Modeling Framework. Welding Research. : 170-171. 6. ASME Section II Part D, 2001 ED: 671-672 and Section IX : 3.

Yeh, M.S., Tseng, Y.H. and Chuang, T.H. Effect of Superplastic Deformation on the Diffusion Welding of SuperDux 65 Stainless steel. In : Welding Research. Miami, American Welding Society : 301-304.

Yilmaz, O. 2001. Effect of welding parameters on diffusion bonding of type 304 stainless steel-copper bimetal. Mater. Sci. Technol. 17(8) : 989-993.

Downloads

Published

2017-04-23

How to Cite

[1]
S. Pitaknorachon and B. . Poopat, “Diffusion bonding of stainless ASTM A240 grade 304 in double side flux cored arc welding”, J Met Mater Miner, vol. 18, no. 1, Apr. 2017.

Issue

Section

Original Research Articles