Effect of milling method on the particle size of calcined 0.65PMN-0.35PT powder

Authors

  • A. Boonruang
  • P. Ngernchuklin
  • C. Eamchotchawalit

Abstract

In this study, stoichiometric 0.65PMN-0.35PT powders have been prepared by columbite method. The perovskite single phase of PMN-PT was successfully synthesized after calcination of the mixed oxide at 900°C/4hr. Due to the particle size of calcined powder has greatly effect on the electrical properties of sintered samples. Therefore, two different milling methods including high energy ball milling (HBM) and conventional ball milling (CBM) were used to grind the calcined powders. The results showed that the particle size distribution of calcined powders from HBM and CBM were 0.17 and 0.19 ?m, respectively. As a result, the relative density of the sintered ceramics prepared from both milling methods were up to 94-95%. Consequently, the greatly electrical properties including d33 at 523 pC/N and K at 4855 (ceramics from HBM) and d33 at 513 pC/N and K at 4675 (ceramics from CBM) were obtained.

Downloads

Download data is not yet available.

Downloads

Published

2012-12-23

How to Cite

[1]
A. Boonruang, P. Ngernchuklin, and C. Eamchotchawalit, “Effect of milling method on the particle size of calcined 0.65PMN-0.35PT powder”, J Met Mater Miner, vol. 22, no. 2, Dec. 2012.

Issue

Vol. 22 No. 2 (2012)

Section

Original Research Articles

License

Authors who publish in this journal agree to the following terms:

    1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.

 

    1. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.